8-74 Phaser 4500 Service Manual
1. Remove the Fuser Assembly (page 8-54).
2. Remove the Gear Assembly Housing (page 8-71).
Note
When removing the Gear Assembly Plate, one of the gears installed on the
Gear Assembly Plate is not secured on its shaft and might come off. Also,
there is a spring inside of the gear that is not secured to the Gear Assembly
Plate. Take care to avoid dropping these parts.
3. Remove the four screws (silver machine, 6 mm) that attach the Gear Assembly
Plate to the frame.
4. Remove the Gear Assembly Plate.
5. Release the locking tab of the bottom side of the connector of the Fuser Harness
Assembly from the frame.
6. Remove Gear 9 from the shaft on the frame.
Replacement Note:
â– When installing, engage the gears of the Gear Assembly Housing, Main
Motor, and Gear Assembly Plate. After assembling, rotate the Main Motor
by hand to check the engagement of the gears.
To Next Page
Loading...
Need help?
General