FRU Disassembly 8-85
1. Remove the Paper Exit Rear Door (page 8-5).
2. Remove the Rear Cover (page 8-6).
3. Disconnect the connector (P/J244) of the Main Fan from the Tray 1 Harness
Assembly.
4. Remove the two screws (tapping, 30 mm) that attach the Main Fan to the frame.
Replacement Note:
■ When installing, make sure the harness wires are not pinched between the
Main Fan and the frame, and make sure the label faces the outside.
To Next Page
Loading...
