FRU Disassembly 8-109
Note
When handling the Nudger Roller or Nudger Gear, avoid touching the rubber
surfaces of the rollers.
1. Remove the optional 550-Sheet Paper Feeder (page 8-93).
Note
The following steps are more easily performed by turning the 550-Sheet
Paper Feeder upside-down.
2. While lifting up the boss of the Left Holder at the back of the optional 550-Sheet
Paper Feeder, shift the Left Holder in the direction of the arrow to remove the 3
hooks.
3. Remove the Left Holder from the Nudger Support. At the same time, the No
Paper Actuator is removed.
4. Release the hook of the Nudger Roller, and pull it out from the Nudger Shaft.
5. Release the hook of the Nudger Gear, and pull it out from the Nudger Shaft.
Replacement Notes:
â– Be sure to install the shafts on both ends of the No Paper Actuator into the
Left Holder and Nudger Support.
â– Assemble the hook of the No Paper Actuator with the Left Holder as shown
in the figure.
To Next Page
Loading...
Need help?
General