FRU Disassembly 8-143
1. Remove the Stacker Rear Cover (page 8-133).
2. Remove the Stacker Cover (page 8-134).
3. Remove the Stacker Front Cover (page 8-137).
4. Unplug the harness connectors at P70, P71, P72, P73, P74 and P75 on the Stacker
PWBA.
5. Remove the two screws (gold tapping, 8 mm) that attach the Right Stacker
Support to the Stacker Housing.
6. Remove the screw (silver, 6 mm) that attaches the Stacker PWBA to the Right
Stacker Support.
7. Remove the Stacker PWBA.
Replacement Notes:
■ Be sure to install the Stacker PWBA into the two guide slots of the Stacker.
■ Be sure that the flag on the Stack Full Actuator is in the gap in the sensor on
the Stacker PWBA.
To Next Page
Loading...
