3-62 WorkCentre C2424 Service Manual
V2V Tray 2 media size sensor unexpectedly activated while print drum maintenance
cycle was being performed.
V2W Tray 2 media size sensor unexpectedly activated during system imaging.
V2X Tray 2 media size sensor unexpectedly activated while exiting print.
1. Ensure ground integrity of the system (see page 4-73).
2. Ensure the Tray 2 paper guides are correctly set.
3. Run the Monitor Sensors test to test the media size sensor.
4. Replace the media size sensor board.
5. Replace the pivot arm.
W2D Tray 3 media size sensor unexpectedly activated during warm-up.
W2E Tray 3 media size sensor unexpectedly activated during system ready.
W2F Tray 3 media size sensor unexpectedly activated while system in fault state.
W2L Tray 3 media size sensor unexpectedly activated while system in standby.
W2M Tray 3 media size sensor unexpectedly activated while picking from Tray 2.
W2N Tray 3 media size sensor unexpectedly activated while picking from Tray 3.
W2P Tray 3 media size sensor unexpectedly activated while picking from Tray 4.
W2Q Tray 3 media size sensor unexpectedly activated while picking from Tray 1.
W2R Tray 3 media size sensor unexpectedly activated while duplexing.
W2V Tray 3 media size sensor unexpectedly activated while print drum maintenance
cycle being performed.
W2x (continued)
W2W Tray 3 media size sensor unexpectedly activated during system imaging.
W2S Tray 3 media size sensor unexpectedly activated while paper staged for print.
W2T Tray 3 media size sensor unexpectedly activated while transfixing the print.
W2X Tray 3 media size sensor unexpectedly activated event while exiting print.
1. Ensure ground integrity of the system (see page 4-73).
2. Ensure the paper guides are correctly set.
3. Run the Monitor Sensors test to test the media size sensor.
4. Replace the 525-Sheet Feeder.
W4N Tray 3 motor stall during pick from Tray 3.
W4P Tray 3 motor stall during pick from Tray 4.
Jam Code Troubleshooting Procedures (Continued)
To Next Page
Loading...
Need help?
General