8-30 WorkCentre C2424 Service Manual
Transfix Load Module
(PL 2.15)
Videos are available with instructions for replacing the Transfix Load
Module. Videos are located on the WorkCentre C2424 Product
Training CD-ROM.
1. Remove the inkloader (page 8-13).
2. Remove the media drive gearbox (page 8-52).
3. Remove the exit module assembly (page 8-42).
4. Remove the duplex roller (page 8-29).
5. Remove the upper duplex guide with solenoid (page 8-44).
6. Insert a T-20 Torxbit through the slotted hole in the transfix load module on the
outside of the plastic arm, through the backside of the housing.
7. Rotate the screwdriver toward the center of the system to release the spring hook.
Caution
Ensure that you lever the spring cam towards the center. Applying the
pressure in the wrong direction can damage the transfix load module.
8. Lift the spring hook off of the transfix load arm, then slowly relax the lever to
return the spring cam to the relaxed position. Repeat steps 7 and 8 on the other
side.
s2424-1
Transfix Load Module
To Next Page
Loading...
Need help?
General