Yamaha 200A - Page 200

60H5E11
Bracket unit
BRKT
7-19
Hydraulic pressure (UP):
10-12 Mpa(100-120 kgf/cm
2
)
Hydraulic pressure gauge:
90890-06776
Down-relief fitting :
90890-06774
5. Connect the power trim and tilt motor leads
to the battery terminals, and fully retract the
trim and tilt rods.
60h70380
6. Connect the power trim and tilt motor leads
to the battery terminals, and fully extend
the trim and tilt rods. Measure the hydrau-
lic pressure while keeping the rods at fully
extended position.
60h70390
7. Replace the up-relief fitting with the down-
relief fitting 5.
60h70400
8. Tighten up the hydraulic pressure gauge
and down-relief fitting.
9. Check the fluid level. If it is lower than the
correct level, add sufficient fluid of the rec-
ommended type. Install the reservoir cap
after checking the fluid level.
NOTE:
If the fluid is at the correct level, the fluid should
overflow out of the check hole when the cap is
removed.
Rods PTT motor leads
Battery
terminal
DOWN
Green(G) +
Blue(L) –
Rods PTT motor leads
Battery
terminal
Blue(L) +
UP
Green(G) –
Hydraulic pressure gauge:
9 N • m (0.9 kgf • m, 6 ft • lb)
Down-relief fitting 5:
4 N • m (0.4 kgf • m, 3 ft • lb)
T
R
.
.