This chapter describes the application functions that you
can set before you start servo system operation. It also
describes the setting methods.
6.1
I/O Signal Allocations . . . . . . . . . . . . . . . . . 6-4
6.1.1 Input Signal Allocations . . . . . . . . . . . . . . . . . . . 6-4
6.1.2 Output Signal Allocations . . . . . . . . . . . . . . . . . . 6-6
6.1.3 ALM (Servo Alarm) Signal . . . . . . . . . . . . . . . . . . 6-8
6.1.4 ALO1 to ALO3 (Alarm Code) Signals . . . . . . . . . . 6-8
6.1.5 /WARN (Warning) Signal . . . . . . . . . . . . . . . . . . . 6-9
6.1.6 /TGON (Rotation Detection) Signal . . . . . . . . . . 6-10
6.1.7 /S-RDY (Servo Ready) Signal . . . . . . . . . . . . . . 6-10
6.2
Operation for Momentary Power Interruptions . 6-12
6.3
SEMI F47 Function . . . . . . . . . . . . . . . . . . 6-13
6.4
Setting the Motor Maximum Speed . . . . . 6-15
6.5
Speed Control . . . . . . . . . . . . . . . . . . . . . . 6-16
6.5.1 Basic Settings for Speed Control . . . . . . . . . . . 6-16
6.5.2 Soft Start Settings . . . . . . . . . . . . . . . . . . . . . . . 6-22
6.5.3 Speed Reference Filter . . . . . . . . . . . . . . . . . . . 6-23
6.5.4 Zero Clamping . . . . . . . . . . . . . . . . . . . . . . . . . 6-23
6.5.5 /V-CMP (Speed Coincidence Detection) Signal . 6-25
6.6
Position Control . . . . . . . . . . . . . . . . . . . . 6-27
6.6.1 Basic Settings for Position Control . . . . . . . . . . 6-28
6.6.2 CLR (Position Deviation Clear) Signal Function
and Settings . . . . . . . . . . . . . . . . . . . . . . . . . . . 6-30
6.6.3 Reference Pulse Input Multiplication Switching . 6-31
6.6.4 Smoothing Settings . . . . . . . . . . . . . . . . . . . . . . 6-32
Application
Functions
6
To Next Page
Loading...
