YASKAWA E-7-Series SGD7S - Write Prohibition Setting for Parameters

5.1 Manipulating Parameters (Pn)
5.1.4 Write Prohibition Setting for Parameters
5-7
5
Basic Functions That Require Setting before Operation
6. Click the Write Button.
Writing will start.
This concludes the procedure to edit the parameter. Proceed to step 7 only when the dialog box
shown in step 7 is displayed.
7. Click the OK Button.
8. To enable changes to the settings, turn the power supply to the SERVOPACK OFF and
ON again.
Setting Parameters with a Digital Operator
Refer to the following manual for information on setting the parameters with a Digital Operator.
Σ-7-Series Digital Operator Operating Manual (Manual No.: SIEP S800001 33)
Setting Parameters with the Panel Operator
Refer to the following section for information on setting the parameters with the Panel Operator.
13.2 Parameter (Pn  ) Operations on the Panel Operator on page 13-6
5.1.4 Write Prohibition Setting for Parameters
You can prohibit writing parameters from the Panel Operator or the Digital Operator.
Even if you do, you will still be able to change parameter settings from the SigmaWin+.
Preparations
No preparations are required.
Applicable Tools
The following table lists the tools that you can use to change the Write Prohibition Setting and
the applicable tool functions.
Tool Function Reference
Panel Operator Fn010
13.4.15 Write Prohibition Setting
(Fn010) on page 13-21
Digital Operator Fn010
Σ-7-Series Digital Operator Operating
Manual (Manual No.: SIEP S800001
33)
SigmaWin+ Setup - Write Prohibited Setting
Operating Procedure on page 5-8