5.1 Manipulating Parameters (Pn)
5.1.4 Write Prohibition Setting for Parameters
5-8
Operating Procedure
Use the following procedure to prohibit or permit writing parameter settings.
1.
Select Setup - Write Prohibited Setting from the menu bar of the Main Window of the
SigmaWin+.
2.
Press the or for the rightmost digit and set one of the following.
0000: Writing is permitted (default setting).
0001: Writing is prohibited.
3.
Click the Setting Button.
4.
Click the OK Button.
The setting will be written to the SERVOPACK.
5.
To enable the new setting, turn the power supply to the SERVOPACK OFF and ON
again.
This concludes the procedure to prohibit or permit writing parameter settings.
Restrictions
If you prohibit writing parameter settings, you will no longer be able to execute some functions.
Refer to the following table.
To Next Page
Loading...
