YASKAWA E-7-Series SGD7S - 3.3 Mounting Hole Dimensions

3.3 Mounting Hole Dimensions
3-4
3.3 Mounting Hole Dimensions
Use mounting holes to securely mount the SERVOPACK to the mounting surface.
Note: To mount the SERVOPACK, you will need to prepare a screwdriver that is longer than the depth of the SER-
VOPACK.
 Σ -7-series Mounting Hole Dimensions

Σ
-V-series-Compatible Mounting Hole Dimensions
If you are replacing a Σ-V-Series SERVOPACK with a Σ-7-Series SERVOPACK, you can also
use the mounting holes that were used for the Σ-V-Series SERVOPACK. Refer to the following
table.
SERVOPACK Model
Dimensions (mm)
Screw
Size
Number
of
Screws
A B C D E F G H
SGD7S-
R70A, R90A,
1R6A
168 5 160 ±0.5 40 35 − 25 − M4 2
2R8A 168 5 160 ±0.5 40 5 − 25 − M4 2
3R8A, 5R5A,
7R6A
168 5 160 ±0.5 70 6 58 ±0.5 64 − M4 3
120A 168 5 160 ±0.5 90 5 80 ±0.5 12.5 − M4 3
180A, 200A 188 5 180 ±0.5 100 95 − 12.5 75±0.5 M4 3
SERVOPACK Model
Dimensions (mm)
Screw
Size
Number
of
Screws
A B C D E F G H
SGD7S-
R70A, R90A,
1R6A
168 5 150 ±0.5 40 35 − 35 − M4 2
2R8A 168 5 150 ±0.5 40 5 − 35 − M4 2
3R8A, 5R5A,
7R6A
168 5 150 ±0.5 70 6 58 ±0.5 6 − M4 3
120A 168 5 150 ±0.5 90 5 80 ±0.5 5 − M4 3
180A, 200A 188 5 170 ±0.5 100 95 − 590 ±0.5 M4 3
D
EF
H
A
BC
G