5.1 Manipulating Parameters (Pn)
5.1.5 Initializing Parameter Settings
5-10
* The Initialize Button will be displayed when you select Parameters - Edit Parameters from the menu bar.
5.1.5
Initializing Parameter Settings
You can return the parameters to their default settings.
This function will not initialize the settings of the parameters that are adjusted for the Fn009,
Fn00A, Fn00B, Fn00C, Fn00D, Fn00E, and Fn00F utility functions.
Preparations
Check the following settings before you initialize the parameter settings.
• The parameters must not be write prohibited.
• The servo must be OFF.
Applicable Tools
The following table lists the tools that you can use to initialize the parameter settings and the
applicable tool functions.
Operating Procedure
Use the following procedure.
1.
Select Parameters - Edit Parameters from the menu bar of the Main Window of the Sig-
maWin+.
Test Opera-
tion
Jogging
Fn002 Jog
Cannot be
executed.
page 7-7
Program Jogging Fn004 Jog Program
Cannot be
executed.
page 7-20
Alarm
Alarm History Display
Fn000 Display Alarm History
Can be
executed.
page 12-41
Alarm History Clear Fn006 Clear Alarm History
Cannot be
executed.
page 12-42
SigmaWin+ Panel Operator or Digital Operator
When Writ-
ing Is Pro-
hibited
Reference
Menu Bar
Button
SigmaWin+ Function
Name
Fn No. Utility Function Name
To enable the new settings, turn the power supply to the SERVOPACK OFF and ON again after
you complete the operation.
Tool Function Reference
Panel Operator Fn005
13.4.5 Initialize Parameters (Fn005) on
page 13-15
Digital Operator Fn005
Σ-7-Series Digital Operator Operating
Manual (Manual No.: SIEP S800001
33)
SigmaWin+ Parameters - Edit Parameters
Operating Procedure on page 5-10
Important
To Next Page
Loading...
