1.4 Model Designations
1.4.1 Interpreting SERVOPACK Model Numbers
1-6
1.4
Model Designations
1.4.1
Interpreting SERVOPACK Model Numbers
1.4.2
Interpreting Servomotor Model Numbers
This section outlines the model numbers of Σ-7-series Servomotors. Refer to the relevant man-
ual in the following list for details.
Σ-7-Series Rotary Servomotor Product Manual (Manual No.: SIEP S800001 36)
Σ-7-Series Linear Servomotor Product Manual (Manual No.: SIEP S800001 37)
Σ-7-Series Direct Drive Servomotor Product Manual (Manual No.: SIEP S800001 38)
Rotary Servomotors
*1 You can use these models with either a single-phase or three-phase input.
*2
The same SERVOPACKs are used for both Rotary Servomotors and Linear Servomotors.
A 200 VAC
R70
*1
R90
*1
1R6
*1
2R8
*1
3R8
5R5
*1
7R6
120
180
200
0.05 kW
0.1 kW
0.2 kW
0.4 kW
0.5 kW
0.75 kW
1.0 kW
1.5 kW
2.0 kW
3.0 kW
00
SGD7S
-
R70
A 00 A
001
A
Maximum Applicable
Motor Capacity
Voltage
Interface
*2
Code
Code
Specication
Code
None
Specication
Without options
Rack-mounted
Varnished
All models
Applicable
Models
Specication
Analog voltage/pulse train reference
Design Revision Order
Hardware Options
Specication
Voltage Code Specication
Three-
Phase,
200 VA
1st+2nd+3rd digits
4th digit
5th+6th digits
7th digit
8th+9th+10th digits
Σ-7-Series
Σ-7S
SERVOPACKs
4th
digit
1st+2nd+3rd
digits
5th+6th
digits
8th+9th+10th
digits
7th
digit
001
002
Code
Specification
Σ-7 Series Servomotors
Series
SGM7 - 01 A F A 2 1
SGM7J
SGM7A
SGM7G
Medium inertia, high speed
Low inertia, high speed
Medium inertia, low speed,
high torque
Rated Output
Power Supply Voltage
Serial Encoder Specification
Shaft End Specification
Straight
With key and tap
With two flat seats
Option Specification
With 24-V holding brake
With oil seal
Design Revision Order
1st+2nd
digits
3rd
digit
4th
digit
5th
digit
6th
digit
7th
digit
1st+2nd digits
3rd digit
4th digit
5th digit
7th digit
6th digit
Series
Code
Specification
7
F
Code
Specification
A 200 VAC
24-bit multiturn absolute encoder
24-bit incremental encoder