YASKAWA E-7-Series SGD7S - Page 298

7.6 Convenient Function to Use during Trial Operation
7.6.3 Test without a Motor
7-29
7
Trial Operation and Actual Operation
Restrictions
The following functions cannot be used during the test without a motor.
• Regeneration and dynamic brake operation
• Brake output signal
Refer to the following section for information on confirming the brake output signal.
9.2.3 I/O Signal Monitor on page 9-5
• Items marked with “×” in the following utility function table
SigmaWin+ Panel Operator or Digital Operator Executable?
Reference
Menu Bar
Button
SigmaWin+ Function
Name
Fn No. Utility Function Name
Motor Not
Connected
Motor
Connected
Setup
Origin Search Fn003 Origin Search 
page 7-25
Resetting the Abso-
lute Encoder
Fn008
Reset Absolute
Encoder
× 
page 5-52
Speed/Torque Refer-
ence Offset Adjust-
ment
Fn009
Autotune Analog
(Speed/Torque) Refer-
ence Offset

page 6-22,
page 6-38
Fn00A
Manually Adjust Speed
Reference Offset

page 6-22
Fn00B
Manually Adjusting the
Torque Reference Off-
set

page 6-38
Analog Monitor Out-
put Adjustment
Fn00C
Adjust Analog Monitor
Output Offset

page 9-8
Fn00D
Adjust Analog Monitor
Output Gain

page 9-8
Motor Current Detec-
tion Offset Adjust-
ment
Fn00E
Autotune Motor Cur-
rent Detection Signal
Offset
× 
page 6-97
Fn00F
Manually Adjust Motor
Current Detection Sig-
nal Offset
× 
Parameter Write Pro-
hibition Setting
Fn010
Write Prohibition Set-
ting

page 5-7
Multiturn Limit Setting Fn013
Multiturn Limit Setting
after Multiturn Limit
Disagreement Alarm
× 
page 6-80
Reset Configuration
Error of Option Mod-
ule
Fn014
Reset Option Module
Configuration Error

page 12-43
Initializing the Vibra-
tion Detection Level
Fn01B
Initialize Vibration
Detection Level
× ×
page 6-93
Setting the Origin of
the Absolute Linear
Encoder
Fn020
Set Absolute Linear
Encoder Origin
× 
page 5-54
Reset Motor Type
Alarm
Fn021
Reset Motor Type
Alarm

−
Software Reset Fn030 Software Reset 
page 6-91
Polarity Detection Fn080 Polarity Detection × ×
page 5-27
Tuning-less Level
Setting
Fn200
Tuning-less Level Set-
ting
× ×
page 8-15
Easy FFT Fn206 Easy FFT × ×
page 8-85
Parameter
Initialize Servo
*
Fn005 Initialize Parameters 
page 5-10