8.5 Estimating the Moment of Inertia
8.5.4 Operating Procedure
8-22
Cancel Button
This button will return you to the Tuning Dialog Box.
15.
Confirm that the Identified Moment of Inertia Ratio Box and the Pn103: Moment of
Inertia Ratio Box show the same value and then click the Finish Button.
16.
Click the OK Button.
17.
Click the Execute Button.
If the setting of the moment of inertia ratio (Pn103) was changed, the new value will be saved and the
Tuning Dialog Box will be displayed again.
This concludes the procedure.
To Next Page
Loading...
