12.11 o: Keypad-Related Settings
1038 YASKAWA SIEPC71061737D GA800 Drive Technical Reference
■ o1-05: LCD Contrast Adjustment
No.
(Hex.)
Name Description
Default
(Range)
o1-05
(0504)
RUN
LCD Contrast Adjustment
Sets the contrast of the LCD display on the keypad.
5
(0 - 10)
When you decrease the setting value, the contrast of the LCD display decreases. When you increase the setting value,
the contrast increases.
■ o1-10: User Units Maximum Value
No.
(Hex.)
Name Description
Default
(Range)
o1-10
(0520)
User Units Maximum Value
Sets the value that the drive shows as the maximum output frequency.
Determined by o1-03
(1 - 60000)
To display a maximum output frequency of 100.00, set parameters to these values:
• o1-10 = 10000
• o1-11 = 2 [User Units Decimal Position = Two Decimal Places (XXX.XX)]
Note:
Set o1-03 = 3 [Frequency Display Unit Selection = User Units (o1-10 & o1-11)] before you set o1-10 and o1-11.
■ o1-11: User Units Decimal Position
No.
(Hex.)
Name Description
Default
(Range)
o1-11
(0521)
User Units Decimal Position
Sets the number of decimal places for frequency reference and monitor values.
Determined by o1-03
(0 - 3)
0 : No Decimal Places (XXXXX)
1 : One Decimal Places (XXXX.X)
2 : Two Decimal Places (XXX.XX)
3 : Three Decimal Places (XX.XXX)
Note:
Set o1-03 = 3 [Frequency Display Unit Selection = User Units (o1-10 & o1-11)] before you set o1-10 [User Units Maximum Value] and o1-
11.
■ o1-24 to o1-35: Custom Monitor 1 to 12
No.
(Hex.)
Name Description
Default
(Range)
o1-24 to o1-35:
(11AD - 11B8)
RUN
Custom Monitor 1 to 12
Sets a maximum of 12 monitors as user monitors. This parameter is only available when using an
LCD keypad.
o1-24: 101
o1-25: 102
o1-26: 103
o1-27 to o1-35: 0
(0, 101 - 999)
These parameters save the monitor items selected by the LCD keypad [Custom Monitor].
To Next Page
Loading...
