5.2 European Standards
240 YASKAWA SIEPC71061737D GA800 Drive Technical Reference
5.2 European Standards
Figure 5.1 CE Mark
The CE Mark identifies that the product meets environmental and safety standards in the European Union. Products
manufactured, sold, or imported in the European Union must display the CE Mark.
European Union standards include standards for electrical appliances (Low Voltage Directive), standards for electrical
noise (EMC Directive), and standards for machinery (Machinery Directive).
This product displays the CE Mark in accordance with the Low Voltage Directive, the EMC Directive, and the
Machinery Directive.
Table 5.1 Harmonized Standards
European Directive Harmonized Standards
CE Low Voltage Directive Compliance
2014/35/EU
IEC/EN 61800-5-1:2007
EMC Directive
2014/30/EU
EN 61800- 3: 2004+A1:2012
Machinery Directive
2006/42/EC
• EN ISO 13849-1:2015 (PL e (Cat.III))
• IEC 62061:2005/A2:2015 (SILCL3)
• EN 62061:2005/A2:2015 (SILCL3)
• IEC/EN 61800-5-2:2007
The customer must display the CE Mark on the final device containing this product. Customers must verify that the
final device complies with EU standards.
◆ EU Declaration of Conformity
Go to www.yaskawa.com and search for “EU Declaration of Conformity” to get an original copy of the EU
Declaration of Conformity.
Yaskawa declares that this product complies with the following directives and standards at our sole responsibility.
◆ CE Low Voltage Directive Compliance
It has been confirmed that this product complies with the CE Low Voltage Directive by conducting a test according to
IEC/EN 61800-5-1:2007.
The following conditions must be satisfied for machines and devices incorporating this product to comply with the
CE Low Voltage Directive.
■ Area of Use
Install this product in a location with Overvoltage Category III and pollution degree 2 or less as specified in IEC/CE
60664.
■ Guarding Against Debris
When you install IP20/UL Open type drives (models: 2xxxxB, 4xxxxB) and IP00/UL Open type drives (models:
TxxxxA), use an enclosure panel that does not let unwanted material enter the drive from above or below.
■ Electrical Installation
Refer to Figure 5.2 and Figure 5.3 for an example of a drive that is wired to comply with the CE Low Voltage
Directive.
To Next Page
Loading...
