YASKAWA GA800

4.6 Keypad Operation
176 YASKAWA SIEPC71061737D GA800 Drive Technical Reference
■ Change the Frequency Reference Value
1. Push to access the screen to change the frequency.
2. Push or to select the digit to change, then push or to change the value.
3. Push to keep the changes.
Note:
The HOME screen must show U1-01 [Frequency Reference] or you must set the keypad as the Run command source (REMOTE) to use this
function.
■ Show the Main Menu
Push to show the main menu. Push [HOME] to go back to the HOME screen.
◆ Show the Monitor
This section shows how to show the standard monitors (Ux-xx).
1. Push [Home] to show the HOME screen.
Note:
• When the drive is in HOME Mode, the screen shows [Home] in the upper right-hand corner of the screen.
• If [Home] is not shown on , push (Back) to show [Home] on .
2. Push (Menu).
3. Push or to select [Monitors], then push .
4. Push or to select [Standard Monitor], then push .