YASKAWA GA800

4.6 Keypad Operation
192 YASKAWA SIEPC71061737D GA800 Drive Technical Reference
6. Push or to select the backed-up parameter data, then push .
The keypad will show the “End” message when the write process is complete.
Note:
The keypad display changes when the settings and conditions change.
A - A1-02 [Control Method Selection] settings
B - o2-04 [Drive Model (KVA) Selection] settings (2 or
3 digits)
C - Presence of DriveWorksEZ parameter backup
D - Parameter backup data is not registered
E - Backup data does not contain the date
Information
F - Backup date
◆ Verify Keypad Parameters and Drive Parameters
This procedure makes sure that the parameter setting values that you backed up in the keypad agree with the
parameter setting values in the drive.
Note:
• Always stop the drive before you start to verify the parameters.
• While you restore parameters, the drive will not accept Run commands.
1. Push (Home) to show the HOME screen.
Note:
• When the drive is in HOME Mode, the screen shows [Home] in the upper right-hand corner of the screen.
• If the screen does not show [Home] for , push (Back), and then push to show [Home].
2. Push (Menu).
3. Push or to select [Parameter Backup/Restore], then push .