4.6 Keypad Operation
180 YASKAWA SIEPC71061737D GA800 Drive Technical Reference
6. Push .
7. Push or to select the monitor number to register, then push .
Monitor Set the x-xx part of the Ux-xx. For example, to show monitor U1-01 [Frequency Reference], set it to
"101" as shown in this figure.
The configuration procedure is complete.
◆ Show Monitors as Bar Graphs
The procedure in this section shows how to show a specific monitor as a bar graph. You can show a maximum of
three.
1. Push (Home) to show the HOME screen.
Note:
• When the drive is in HOME Mode, the screen shows [Home] in the upper right-hand corner of the screen.
• If the screen does not show [Home] for , push (Back), and then push to show [Home].
2. Push (Menu).
3. Push or to select [Monitors], then push .
4. Push or to select [Display Bar Graph], then push .
To Next Page
Loading...
