Startup Procedure and Test Run
4
4.4 Start-up Procedures
YASKAWA SIEPC71061737D GA800 Drive Technical Reference 171
Figure 4.10 PM Motor Auto-Tuning and Test Run Procedure
*1 For Yaskawa PM motors (SMRA-series, SSR1-series, or SST4-series), set E5-01 [PM Motor Code Selection]. For PM motors from a
different manufacturer, set E5-01 = FFFF.
*2 Be sure to release the holding brake before doing Inertia Tuning.
*3 In ASR Tuning, the drive will automatically tune Feed Forward control and KEB Ride-Thru 2 parameters.
◆ Subchart A-3: EZ Open Loop Vector Control Test Run Procedure
Subchart A-3 gives the setup procedure to run a PM motor in EZ Open Loop Vector Control.
To Next Page
Loading...
