YASKAWA GA800

4.6 Keypad Operation
178 YASKAWA SIEPC71061737D GA800 Drive Technical Reference
5. Push or to select [Custom Monitor 1], then push .
6. Push or to select the monitor number to register, then push .
Set the x-xx part of monitor Ux-xx. For example, to show monitor U1-05, set it to “105” as shown in this figure.
The configuration procedure is complete.
◆ Show Custom Monitors
The procedure in this section shows how to show the registered custom monitors.
1. Push [Home] to show the HOME screen.
Note:
• The keypad will [Home] in the top right corner when the HOME screen is active.
• If [Home] is not shown on , push [Back] to show [Home] on .
2. Push [Menu].
3. Push or to select [Monitors], then push .
4. Push or to select [Custom Monitor], then push .
The keypad shows the selected monitor as shown in this figure.