YASKAWA GA800

Electrical Installation
3
3.9 Braking Resistor Installation
YASKAWA SIEPC71061737D GA800 Drive Technical Reference 135
A - Cutaway sections B - Use a diagonal-cutting pliers to clip this area.
Figure 3.77 Cutaway Sections
A - Cutaway sections B - Use a diagonal-cutting pliers to clip this area.
Figure 3.78 Cutaway Sections
■ Installing a Braking Unit Connection (CDBR-Type)
Remove the terminal cover before you connect the braking unit (CDBR-type) to the drive.
1. Remove the screws on the terminal block cover and pull the terminal block cover away from the terminal
block. Pull the wiring cover away from the drive to remove the wiring cover after removing the terminal block
cover.
Note:
6-Phase/12-pulse drives (models: Txxx) do not have the wiring covers.
A - Terminal block cover B - Wiring cover
Figure 3.79 Remove the Wiring Cover
2. Examine the signal from the wired terminal and use a diagonal-cutting pliers to remove areas of the wiring
cover cutaway section.
Note:
6-Phase/12-pulse drives (models: Txxx) do not have the wiring covers.