Electrical Installation
3
3.9 Braking Resistor Installation
YASKAWA SIEPC71061737D GA800 Drive Technical Reference 137
5. Remove the main circuit terminal block nut.
A - Nut
Figure 3.82 Remove the Terminal Block Nut
6. Wire the closed-loop crimp terminal to the main circuit terminal block.
Figure 3.83 Connect the Wire
7. Tighten the nut to the specified torque.
Figure 3.84 Tighten the Terminal Block Nut
8. Attach the wiring cover and terminal block cover to their initial positions and tighten the screws on the terminal
block cover.
Note:
6-Phase/12-pulse drives (models: Txxx) do not have the wiring covers.
To Next Page
Loading...
