Parameter Details
12
12.8 H: Terminal Functions
YASKAWA SIEPC71061737D GA800 Drive Technical Reference 887
Note:
Refer to Setting Procedures for Multi-step Speed Operation on page 796 for more information.
■ 4: Multi-Step Speed Reference 2
Setting Value Function Description
4 Multi-Step Speed Reference
2
Uses speed references d1-01 to d1-16 to set a multi-step speed reference.
Note:
Refer to Setting Procedures for Multi-step Speed Operation on page 796 for more information.
■ 5: Multi-Step Speed Reference 3
Setting Value Function Description
5 Multi-Step Speed Reference
3
Uses speed references d1-01 to d1-16 to set a multi-step speed reference.
Note:
Refer to Setting Procedures for Multi-step Speed Operation on page 796 for more information.
■ 6: Jog Reference Selection
Setting Value Function Description
6 Jog Reference Selection
Sets the drive to use the JOG Frequency Reference (JOG command) set in d1-17. The JOG Frequency Reference (JOG command)
overrides Frequency References 1 to 16 (d1-01 to d1-16).
■ 7: Accel/Decel Time Selection 1
Setting Value Function Description
7 Accel/Decel Time Selection
1
Sets the drive to use Acceleration/Deceleration Time 1 [C1-01, C1-02] or Acceleration/Deceleration Time 2 [C1-03, C1-04].
Note:
Refer to C1: Accel & Decel Time on page 769 for more information.
■ 8: Baseblock Command (N.O.)
Setting Value Function Description
8 Baseblock Command (N.O.)
Sets the command that stops drive output and coasts the motor to stop when the input is ON.
The keypad flashes bb [Baseblock]. If you cancel the baseblock command when the Run command is active, the drive
will restart the motor and use the speed search function.
Figure 12.79 Baseblock Command Time Chart
ON : Baseblock (drive output stop)
OFF : Normal operation
To Next Page
Loading...
