Yealink VS800 - Page 149

| Configuring Camera Settings | 149
Parameter Description Configuration Method
Exposure Compensation
Configure the value of exposure
compensation.
The exposure compensation
is used to compensate the
camera effectively when the
camera is shooting in a backlight
environment. If the environment
light is dark, you can increase
the compensation value.
Valid value: from -6 to 6.
Default: 0.
Web user interface
Endpoint
CTP20
Flicker
Configure the value of the
camera flicker frequency.
The supported types are as
follows:
• 50 Hz
• 60 Hz
The indoor lights powered by a
50Hz or 60Hz power source may
produce a flicker. You can adjust
the camera flicker frequency
according to the power source
that the light is powered by.
Default: 50 Hz.
Web user interface
Endpoint
CTP20
Gain/Gain Limit
Specify the value.
Valid value: 1 - 15. Default: 4.
Web user interface
Endpoint
CTP20
WDR/Wide Dynamic Range
Specify the WDR. The value
represents the compression
degree of the dynamic range.
Cameras with WDR technology
can work perfectly both in the
bright and the dark conditions
and present clear images that
balances different lighting, so
that you can identify the details.
• Off-do not use WDR.
• 1~5
Default: 2.
Web user interface
Endpoint
CTP20