| Configuring Camera Settings | 161
Parameter Description Configuration Method
FECC (SIP)
Enable or disable the FECC
(SIP) protocol for the far site to
control the near camera.
Note:
For Zoom/Pexip/BlueJeans/
EasyMeet/Videxio/Custom and
SIP IP call, BFCP is enabled by
default.
For SIP account, the default
value is off.
Web user interface
Configuring the Far Site to Control the Near Camera
You can enable this feature to allow the remote to control your local camera, so that the image captured by the local
camera can be displayed properly on the remote monitor. This feature is not applicable to VP59.
Procedure
1.
Do one of the following:
• On your web user interface, go to Setting > Video & Audio > Far Control Near Camera.
• On your VCS, go to More > Setting > Video & Audio.
• On your CTP20, tap Setting > Camera > Far Control Near Camera.
2.
Configure and save the following settings:
Parameter Description Configuration Method
Far Control Near Camera
Enable or disable the far site to
control the near-site camera.
Default: On.
Web user interface
Remote control
CTP20
Setting the Camera Presets
The camera presets store the setting of the angle and the focal length. The camera presets can help you quickly point
a camera at pre-defined locations. The camera presets can remain in effect until you change them. This feature is not
applicable to VP59.
Procedure
1.
On your web user interface, go to Home > Yourself > .
To Next Page
Loading...
