| Accessories with Your System | 210
Viewing the Information of Bluetooth Wireless Microphones
Procedure
1.
Do one of the following:
• On your web user interface, go to Setting > Wireless Microphone.
• On your VCS, go to More > Setting > Video & Audio > Wireless Microphone, and select the desired
wireless microphone.
• On your CTP20, go to Setting > Audio > Wireless Microphone, and select the desired wireless microphone.
2.
Select a desired microphone to view the information.
Finding the Registered CPW90-BT
Procedure
1.
Do one of the following:
• On your web user interface, go to Setting > Wireless Microphone.
• On your VCS, go to More > Setting > Video & Audio > Wireless Microphone.
• On your CTP20, tap Setting > Audio > Wireless Microphone.
2.
Select a wireless microphone and then select Find.
The mute indicator LED on the CPW90-BT flashes red and green alternately.
Using CTP20
•
Wired Connection to CTP20
•
Wireless Connection to CTP20
•
Using Multiple CTP20s for Collaboration
Wired Connection to CTP20
After connected to the VC Hub/Phone port via the network cable, CTP20 will be connected to the VCS automatically.
For more information, refer to Yealink_CTP20_Quick_Start_Guide.
Wireless Connection to CTP20
If the VC Hub/Phone port of the VCS codec is used, you can connect the CTP20 to the PoE switch for power supply,
also to the wireless access point provided by the VCS codec.
Before you begin
Make sure the Wireless AP is enabled and the codec is connected to WF50.
About this task
If the codec connects to the wireless network and the Wireless AP is disabled, the CTP20 cannot use the wireless
connection.
Procedure
1.
Enable Wi-Fi.
2.
Select the Wi-Fi supplied by the VCS codec.
3.
Enter the password and tap OK.
After connecting to the wireless network, you can use the CTP20 to work with VCS codec.
To Next Page
Loading...
