Yealink VS800 - Configuring Ipv6

| Configuring Network Settings | 55
Parameter Description Configuration Method
Secondary DNS/DNS
Secondary Server
Configure the secondary DNS
server assigned to the system.
If you change this parameter, the
system will reboot to make the
change take effect.
Web user interface
Endpoint
CTP20
Configuring IPv6
The system can automatically obtain the network parameters via DHCPv6. You can also manually configure IPv6
network. Make sure that your network environment supports IPv6.
Before you begin
Make sure that your network mode is set to IPv6 or IPv4&IPv6.
Procedure
1.
Do one of the following:
• On your web user interface, go to Network > LAN Configuration > IPv6 Config.
• On your VCS:
For VC880/VC800/VC500/PVT980/PVT950, go to More > Setting > Advanced > Wired Network > IPv6.
On your VC200, go to More > Network > Wired Network > IPv6.
On your VP59, go to Setting > Advanced > Wired Network > IPv6.
• On your CTP20, tap Setting > Advanced > Wired Network > Wired Network > IPv6.
2.
Configure and save the following settings:
Parameter Description Configuration Method
DHCP
Enable or disable the system to
obtain network settings from the
DHCP server
Note: the default value is On.
If you change this parameter, the
system will reboot to make the
change take effect.
Web user interface
Endpoint
CTP20
Static IP
Enable or disable the system
to manually configured IPv6
network settings.
Note: the default value is Off.
If you change this parameter, the
system will reboot to make the
change take effect.
Web user interface
IP address
Configure the IPv6 address
assigned to the system.
If you change this parameter, the
system will reboot to make the
change take effect.
Web user interface
Endpoint
CTP20