| Configuring Network Settings | 61
Parameter Description Configuration Method
Option
Specify the DHCP option
from which the system obtains
the VLAN settings. You can
configure at most 5 DHCP
options and separate them by
commas.
Note: the value can be any
integer from 128 to 254.
Default: 132.
If you change this parameter, the
system will reboot to make the
change take effect.
Web user interface
Wi-Fi
For VC880/VC800/VC500/PVT980/PVT950: you need to connect a WF50 Wi-Fi USB Dongle to the system for
connecting to the wireless network. For VC200: you can connect to the wireless network directly.
•
Connecting to the Wireless Network
•
Viewing the Wireless Network Status
•
Forgetting a Wi-Fi
•
Disabling the Wi-Fi Feature
Connecting to the Wireless Network
There are two ways to connect to the wireless network:
• Manually connect to an available wireless network
• Manually connect to hidden wireless network
When the system connects to a wireless network, the Wi-Fi icon will display on the status bar. The Wi-Fi icon
indicates the signal strength. The more arcs you see, the stronger the signal strength is.
Note: If you connect the codec to the wireless network via CTP20, make sure that CTP20 is wired to the
codec.
•
Connecting to the Wireless Network
•
Connecting to a Hidden Wireless Network
Connecting to the Wireless Network
You can manually connect your phone to a wireless network.
Procedure
1.
Do one of the following:
• On your VCS:
For VC880/VC800/VC500/PVT980/PVT950, go to More > Setting > Advanced > Wi-Fi.
On your VC200, go to More > Network > Wi-Fi.
On your VP59, tap Setting > Network & Connection > Wi-Fi.
• On your CTP20, tap Setting > Advanced > Wired Network > Wireless Network.
2.
Enable Wi-Fi.
To Next Page
Loading...
