Yealink VS800 - Logging out of the Video Conference Platform

| Configuring Account Settings | 96
Parameter Description Configuration Method
Transport
Configure the transport protocol
for transmitting the SIP
signaling.
The supported protocols are as
follows:
• UDP—it provides the
best transmission for SIP
signaling.
• TCP—it provides a reliable
transmission for SIP
signaling.
• TLS—it provides a safe
transmission for SIP
signaling. TLS is available
only when the device is
registered on a SIP server
that supports TLS.
• DNS-NAPTR—the device
performs the DNS NAPTR
and SRV request to find the
service type and the port if
no server port is given.
Default: TCP.
Web user interface
Server Expires
The registration timeout (in
seconds) of the device.
After the timeout, the device will
send the registration request to
the server again.
Default: 3600 seconds.
Web user interface
Keep Alive Interval
Configure the interval (in
seconds) that the device sends
keep-alive messages to the SIP
server, so that the SIP server can
remain connected to the device.
Default: 30 seconds.
Web user interface
Logging out of the Video Conference Platform
Procedure
1.
Do one of the following:
• On your web user interface, go to Account > VC Platform > Log Out.
• On your VCS, go to More > Setting > Advanced > Video Conference Platform > Log out.
On your VP59, tap Setting > Advanced > Video Conference Platform > Log out.
• On your CTP20, go to Setting > Advanced > Video Conference Platform > Log out.
It prompts whether to log out the current account.