Yealink VS800 - Configuring the Mode of WDR-Auto; Configuring WDR-Manual

| Configuring Camera Settings | 155
Configuring the Mode of WDR-Auto
WDR mode is not applicable to VC200.
Procedure
1.
Do one of the following:
• On your web user interface, go to Setting > Camera > Exposure.
• For VC880/VC800/VC500/PVT980/PVT950, go to More > Setting > Camera Setting > Exposure.
• On your CTP20, tap Setting > Camera > Exposure.
2.
Select WDR-Auto from the drop-down menu of Exposure Mode.
3.
Configure and save the following settings:
Parameter Description Configuration Method
Exposure
Compensation
Configure the value of exposure
compensation.
The exposure compensation is used to
compensate the camera effectively when
the camera is shooting in a backlight
environment. If the environment light is
dark, you can increase the compensation
value.
Note: the valid value is from -6 to 6. The
default value is 0.
Web user interface
Endpoint
CTP20
Configuring WDR-Manual
WDR-Manual mode is not applicable to VC200.
Procedure
1.
Do one of the following:
• On your web user interface, go to Setting > Camera > Exposure.
• For VC880/VC800/VC500/PVT980/PVT950, go to More > Setting > Camera Setting > Exposure.
• On your CTP20, tap Setting > Camera > Exposure.
2.
Select WDR-Auto from the drop-down menu of Exposure Mode.
3.
Configure and save the following settings:
Parameter Description Configuration Method
Exposure
Compensation
Configure the value of exposure
compensation.
The exposure compensation is used to
compensate the camera effectively when
the camera is shooting in a backlight
environment. If the environment light is
dark, you can increase the compensation
value.
Valid value: from -6 to 6. Default: 0.
Web user interface
Endpoint
CTP20