| Configuring Camera Settings | 154
• On your web user interface, go to Setting > Camera > Exposure.
• On your VCS:
For VC880/VC800/VC500/PVT980/PVT950, go to More > Setting > Camera Setting > Exposure.
On your VC200, go to More > Setting > Video & Audio > Exposure.
• On your CTP20, tap Setting > Camera > Exposure.
2.
Select Brightness Priority as the Exposure Mode.
3.
Configure and save the following settings:
Parameter Description Configuration Method
Brightness
Configure the value of brightness.
Note: the valid value is from 0 to 14 and the
default value is 6.
Web user interface
Endpoint
CTP20
Flicker
Configure the value of camera flicker
frequency.
The supported types are as follows:
• 50 Hz
• 60 Hz
The indoor lights powered by a 50Hz or 60Hz
power source may produce a flicker. You can
adjust the camera flicker frequency according
to the power source that the light is powered
by.
Default: 50 Hz.
Web user interface
Endpoint
CTP20
WDR/Wide
Dynamic Range
Specify the WDR. The value represents the
compression degree of the dynamic range
Cameras with WDR technology can work
perfectly both in the bright and the dark
conditions and present clear images that
balances different lighting, so that you can
identify the details.
• Off-do not use WDR.
• 1~5
Default: 2.
Web user interface
Endpoint
CTP20
Metering
Configure the value of metering.
• Average
• Central
• Bottom
• Top
Default: Average.
Web user interface
Endpoint
CTP20
To Next Page
Loading...
