Yealink VS800 - Configuring Wireless Access Point

| Configuring Network Settings | 64
Configuring Wireless Access Point
You can configure the wireless access point for the devices.
Before you begin
Make sure you enable wireless access point.
Procedure
1.
Do one of the following:
• On your web user interface, go to Network > Wireless AP.
• On your VCS:
For VC880/VC800/VC500/PVT980/PVT950, go to More > Setting > Advanced > Wireless AP > Configure
AP.
On your VC200, go to More > Network > Wireless AP > Configure AP.
On your VP59, tap Setting > Network & Connection > Wireless AP > Configure AP.
• On your CTP20, tap Setting > Advanced > Wired Network > Wireless AP > Configure AP.
2.
Configure and save the following settings:
Parameter Description Configuration Method
AP name Configure the name of wireless
AP.
Web user interface
Endpoint
CTP20
Security mode
Configure the security mode of
the wireless AP.
• None
• WPA2-PSK
Default: WPA2-PSK.
Web user interface
Endpoint
CTP20
AP Password
Configure the password of the
wireless AP.
Note: only when the security
mode is WPA2-PSK do you
need to configure this parameter.
Web user interface
Endpoint
CTP20
Network Sharing
Enable or disable the system to
share its wired network to the
connected devices.
• On—The connected
devices can use an Internet
connection.
• Off—The connected devices
cannot use an Internet
connection.
Default: Off.
Web user interface