Yealink VS800 - Configuring Account Settings; Configuring SIP Settings

| Configuring Account Settings | 73
Parameter Description Configuration Method
Restricted Single Packet Mode
Enable or disable the restricted
single packet mode.
• Off—sends data packets by
using multiple packets mode.
• On—sends data packets by
using single packet mode.
Note: the default value is Off.
Some third-party devices only
accept the data packets sent by
single packet mode. If local
system sends data packets by
using multiple packets mode,
the video call may appear
the mosaic phenomenon. To
avoid this situation, enable
this Restricted Single Packet
Mode.
If you change this parameter, the
system will reboot to make the
change take effect.
Web user interface
Configuring Account Settings
This chapter provides information on how to configure account settings.
•
Configuring SIP Settings
•
Configuring H.323 Settings
•
Configuring PSTN
•
Configuring the Video Conference Platform
•
Configuring the Third-party Virtual Meeting Room
Configuring SIP Settings
Yealink video conferencing system supports Session Initiation Protocol (SIP). If your server supports SIP, you can use
SIP to establish calls.
•
Configuring SIP Accounts
•
Configuring SIP IP Call
Configuring SIP Accounts
Yealink video conferencing system supports Session Initiation Protocol (SIP). If your server supports SIP, you can
configure a SIP account for your device, and other users can call you by dialing your SIP account.
Procedure
1.
Do one of the following:
• On your web user interface, go to Account > SIP Account.