Yealink VS800 - Page 74

| Configuring Account Settings | 74
• On your VCS, go to More > Setting > Advanced > SIP Account.
On your VP59, tap Setting > Advanced > SIP Account.
• On your CTP20, tap Setting > Advanced > SIP Account.
2.
Configure and save the following settings:
Parameter Description Configuration Method
Account Active/SIP Account
Enable or disable SIP Accounts.
Note: the default value is On. If
it is set to disabled, the devices
cannot place or receive calls via
the SIP protocol.
Web user interface
Endpoint
CTP20
Username
The username of this SIP
account.
Default: blank.
Web user interface
Endpoint
CTP20
Register Name
The registration name of this SIP
account.
Default: blank.
Web user interface
Endpoint
CTP20
Password
The registration password of this
SIP account.
Default: blank.
Web user interface
Endpoint
CTP20
Server Host/Server
The IP address or domain name
of the SIP server.
Default: blank.
Web user interface
Endpoint
CTP20
Port
Specify the port of the SIP
server.
Note: the default port number
is 5060. The value can be any
integer from 0 to 65535.
Web user interface
Endpoint
CTP20
Enable Outbound Proxy
Server/Outbound
Enable or disable the device to
send requests of the SIP account
to the outbound proxy server.
Default: Off.
Web user interface
Endpoint
CTP20
Outbound Proxy Server/
Outbound Server
Configure the IP address or the
domain name of the outbound
proxy server for this SIP
account.
Note: only the outbound proxy
server is enabled do you need to
configure this parameter.
Web user interface
Endpoint
CTP20