| Configuring Network Settings | 67
2.
Disable the wireless AP.
802.1x Authentication
You can use 802.1x authentication to restrict the unauthorized devices to accessing the LAN. The 802.1x
authentication can be used to authenticate the devices connected to the port before the system obtains all the
businesses.
The system supports the following protocols for 802.1X authentication:
• EAP-MD5
• EAP-TLS (Device and CA certificates are required, password is not required)
• EAP-PEAP/MSCHAPv2 (CA certificates are required)
• EAP-TTLS/EAP-MSCHAPv2 (CA certificates are required)
For more information on 802.1X authentication, refer to Yealink 802.1X Authentication.
•
Configuring the 802.1x Authentication
Configuring the 802.1x Authentication
Procedure
1.
Do one of the following:
• On your web user interface, go to Network > Advanced > 802.1x.
• On your VCS:
For VC880/VC800/VC500/PVT980/PVT950, go to More > Setting > Advanced > Advanced Network >
802.1x Mode.
On your VC200, go to More > Network > Wired Network > Advanced Network > 802.1 Mode.
On your VP59, tap Setting > Advanced > Advanced Network > 802.1 Mode.
• On your CTP20, tap Setting > Advanced > Advanced Network > 802.1 Mode.
2.
Configure and save the following settings:
Parameter Description Configuration Method
802.1x Mode
Specify the 802.1x
authentication mode.
• Disabled
• EAP-MD5
• EAP-TLS
• PEAP-MSCHAPv2
• EAP-TTLS/EAP-
MSCHAPv2
Note: the default value is
disabled.
If you change this parameter, the
system will reboot to make the
change take effect.
Web user interface
Endpoint
CTP20
To Next Page
Loading...
