Yealink VS800 - Configuring the Security Features; User and Administrator

| Configuring the Security Features | 195
Configuring the Security Features
The following introduces how to configure the security features.
•
User and Administrator
•
Configuring the Auto Logout Time
•
Transport Layer Security (TLS)
User and Administrator
•
Configuring an Administrator Password
•
Enabling the User Role
Configuring an Administrator Password
The default administrator name is “admin” and the administrator password is “0000”. Only the user with the
administrator permission can change the password. For security reasons, you should change them as soon as possible.
The administrator password for the system supports ASCII characters 32-126 (0x20-0x7E).
Procedure
1.
Do one of the following:
• On your web user interface, go to Security > Security.
• On your VCS, go to More > Setting > Advanced > Password Reset.
On your VP59, tap Setting > Advanced > Password Reset.
• On your CTP20, tap Setting > Advanced > Password Reset.
2.
Configure and save the following settings:
Parameter Description Configuration Method
User Type Select the administrator. Web user interface
Old Password/Current
Password
Enters the old administrator
password.
Default: “0000 ”.
Web user interface
Endpoint
CTP20
New Password
Configure a new administrator
password.
Note: You can leave the
password blank.
Web user interface
Endpoint
CTP20
Confirm Password
Enters the new configured
administrator password.
Note: The entered password
must be the same as the one
configured by the parameter
“New Password”.
Web user interface
Endpoint
CTP20