Yealink VS800 - Page 158

| Configuring Camera Settings | 158
Parameter Description Configuration Method
Sharpness
Configure the sharpness of the
camera's image.
The sharpness is an indicator
that reflects the definition of the
image plane and the sharpness
of image edge. Increasing
the sharpness will improve
the definition of the image.
However, if the sharpness is set
too high, the image will look
distorted and glaring.
Valid value: 0 - 100. Default:
15.
Web user interface
Endpoint
CTP20
Brightness
Configure the brightness of the
camera's image.
Valid value: 0 - 100. Default:
50.
Web user interface
Endpoint
CTP20
Contrast
Configure the contrast of the
camera's image.
Valid value: 0 - 100. Default:
49.
Web user interface
Endpoint
CTP20
Noise Reduction (2D)
Specify the noise reduction (2D)
mode.
The available modes are
described as below:
• Off
• Low
• Middle
• High
Default: Middle.
Web user interface
Endpoint
CTP20
Noise Reduction (3D)
Specify the noise reduction (3D)
mode. It indicates the coefficient
of the reduced noise in the
image. The higher the coefficient
is, the smaller the noise is.
Valid value: 0 - 22. Default: 3.
Web user interface
Endpoint
CTP20