User Preferences & Miscellaneous Options 9 - 3
Night Mode Toggle N/A N/A N/A
9-14
Low Power Mode 128 80h Disable
9-15
Time Delay to Low Power Mode 146 92h 1 Hour
9-16
Trigger Mode (or Hand-held Trigger Mode) 138 8Ah Auto Aim
9-18
Hands-free Mode 630 F1h 76h Enable
9-19
Hand-held Decode Aiming Pattern 306 F0h 32h Enable
9-20
Presentation (Hands-free) Decode Aiming
Pattern
590 F1h 4Eh Enable Presentation
(Hands-free) Decode
Aiming Pattern on PDF
9-21
Picklist Mode 402 F0h 92h Disable Picklist Mode
Always
9-22
Continuous Bar Code Read 649 F1h 89h Disable
9-23
Unique Bar Code Reporting 723 F1h D3h Enable
9-23
Decode Session Timeout 136 88h 9.9 Seconds
9-24
Hands-free Decode Session Timeout 400 F0h 90h 15
9-24
Timeout Between Decodes, Same Symbol 137 89h 0.5 Seconds
9-25
Timeout Between Decodes, Different
Symbols
144 90h 0.1 Seconds
9-25
Triggered Timeout, Same Symbol 724 F1h D4h Disable
9-26
Mobile Phone/Display Mode 716 F1h CCh Normal
9-27
PDF Prioritization 719 F1h CFh Disable
9-28
PDF Prioritization Timeout 720 F1h D0h 200 ms
9-28
Presentation (Hands-free) Mode Field of
View
609 F1h 61h Full
9-29
Decoding Illumination 298 F0h 2Ah Enable
9-29
Illumination Brightness 669 F1h 9Dh High
9-30
Motion Tolerance (Hand-held Trigger Mode
Only)
858 F2h 5Ah Less
9-31
Table 9-1 User Preferences Parameter Defaults (Continued)
Parameter
Parameter
Number
1
SSI
Number
2
Default
Page
Number
1. Parameter number decimal values are used for programming via RSM commands.
2. SSI number hex values are used for programming via SSI commands.