11 - 2 DS8108 Digital Scanner Product Reference Guide
Scanning Sequence Examples
In most cases, scanning one bar code sets the parameter value. For example, to transmit bar code data without the
UPC-A check digit, scan the Do Not Transmit UPC-A Check Digit bar code under Transmit UPC-A Check Digit
on page 11-19. The scanner issues a fast warble beep and the LED turns green, signifying a successful parameter
entry.
Other parameters require scanning several bar codes. See the parameter descriptions for this procedure.
Errors While Scanning
Unless otherwise specified, to correct an error during a scanning sequence, just re-scan the correct parameter.
Symbology Parameter Defaults
Table 11-1 lists defaults for all symbology parameters. Change these values in one of two ways:
•
Scan the appropriate bar codes in this chapter. The new value replaces the standard default value in
memory. To recall the default parameter values, see Default Parameters on page 9-5.
•
Configure the scanner using the 123Scan
configuration program. See Chapter 16, 123Scan and Software
Tools.
NOTE See Appendix A, Standard Parameter Defaults for all user preference, host, symbology, and
miscellaneous default parameters.
Table 11-1 Symbology Parameter Defaults
Parameter
Parameter
Number
1
SSI Number
2
Default
Page
Number
Enable/Disable All Code Types
11-8
1D Symbologies
UPC/EAN/JAN
UPC-A 1 01h Enable
11-9
UPC-E 2 02h Enable
11-9
UPC-E1 12 0Ch Disable
11-10
EAN-8/JAN 8 4 04h Enable
11-10
EAN-13/JAN 13 3 03h Enable
11-11
Bookland EAN 83 53h Disable
11-11
Bookland ISBN Format 576 F1h 40h ISBN-10
11-12
ISSN EAN 617 F1h 69h Disable
11-13
1. Parameter number decimal values are used for programming via RSM commands.
2. SSI number hex values are used for programming via SSI commands.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
