USB Interface 4 - 5
USB Host Parameters
USB Device Type
Scan one of the following bar codes to select the USB device type. To select a country keyboard type for the USB
Keyboard HID host, see Appendix G, Country Codes..
NOTE When changing USB Device Types, the scanner resets and issues the standard startup beep sequences.
NOTE When connecting two scanners to a host, IBM does not allow selecting two of the same device type. If you
require two connections, select IBM Table-top USB for one scanner and IBM Hand-held USB for the
second scanner.
NOTE Select IBM Hand-held USB to disable data transmission when an IBM register issues a Scan Disable
command. Aim, illumination, and decoding is still permitted. Select IBM OPOS (IBM Hand-held USB with
Full Scan Disable) to completely shut off the scanner when an IBM register issues a Scan Disable
command, including aim, illumination, decoding, and data transmission.
NOTE To select the Toshiba TEC device type, refer to the Toshiba TEC Programmer’s Guide.
*
USB Keyboard HID
IBM Table-top USB
IBM Hand-held USB
IBM OPOS
(IBM Hand-held USB with Full Scan Disable)