CHAPTER 10 IMAGE CAPTURE
PREFERENCES
Introduction
You can program the imager to perform various functions, or activate different features. This chapter describes
image capture preference features and provides programming bar codes for selecting these features.
The imager ships with the settings shown in Table 10-1 on page 10-2 (also see Appendix A, Standard Parameter
Defaults for all defaults). If the default values suit requirements, programming is not necessary.
Setting Parameters
To set feature values, scan a single bar code or a short bar code sequence. The settings are stored in non-volatile
memory and are preserved even when the imager powers down.
To return all features to default values, scan the Set Factory Defaults on page 9-5. Throughout the programming
bar code menus, asterisks (
*) indicate default values.
NOTE Only the Symbol Native API (SNAPI) with Imaging interface supports image capture. See USB Device
Type on page 4-5 to enable this host.
NOTE Most computer monitors allow scanning bar codes directly on the screen. When scanning from the screen,
be sure to set the document magnification to a level where you can see the bar code clearly, and bars
and/or spaces do not merge.
*Enable Parameter
(1)
Feature/option
* Indicates default
Option value
To Next Page
Loading...
Need help?
General
Weight and Dimensions
