Zebra DS8108

To Next Page

To Previous Page

APPENDIX I CJK DECODE CONTROL

Introduction

This appendix describes control parameters for CJK (Chinese, Japanese, Korean) bar code decode through USB

HID Keyboard Emulation mode.

NOTE Because ADF does not support CJK character processing, there is no format manipulation for CJK output.

Main Page

DS8108 Digital Scanner Product Reference Guide1
- Warranty4
- Revision History5
About This Guide21
- Introduction21
- Configurations21
- Related Product Line Configurations/Accessories22
  - Cables22
- Chapter Descriptions22
- Notational Conventions23
- Related Documents and Software24
- Service Information25
Chapter 1 Getting Started27
- Introduction27
- Interfaces28
- Unpacking28
- Setting Up the Digital Scanner29
Chapter 2 Data Capture31
- Introduction31
- Beeper and LED Indicators32
- Scanning34
- Decode Ranges39
  - DS8108-SR/DL Configurations39
  - DS8108-HC Configurations40
- Assembling the Document Capture Stand41
  - Assembly42
Chapter 3 Maintenance, Troubleshooting, & Technical Specifications45
- Introduction45
- Maintenance45
- Troubleshooting48
  - Dump Scanner Parameters50
  - Send Versions51
- Technical Specifications52
- Digital Scanner Signal Descriptions55
Chapter 4 USB Interface57
- Introduction57
- Setting Parameters57
  - Scanning Sequence Examples57
  - Errors While Scanning58
- Connecting a USB Interface58
- USB Parameter Defaults60
- USB Host Parameters61
- ASCII Character Sets73
Chapter 5 SSI Interface75
- Introduction75
- Communication75
  - SSI Commands76
- SSI Transactions77
  - General Data Transactions77
    - ACK/NAK Handshaking77
  - Decoded Data Transmission78
- Communication Summary79
- Using Time Delay to Low Power Mode with SSI81
- Encapsulation of RSM Commands/Responses over SSI82
- Setting Parameters84
  - Scanning Sequence Examples84
  - Errors While Scanning84
- Simple Serial Interface Parameter Defaults85
- SSI Host Parameters86
- Event Reporting96
Chapter 6 RS-232 Interface99
- Introduction99
- Setting Parameters99
  - Scanning Sequence Examples100
  - Errors While Scanning100
- Connecting an RS-232 Interface100
- RS-232 Parameter Defaults101
- RS-232 Host Parameters102
- ASCII Character Sets116
Chapter 7 IBM 468X / 469X Interface117
- Introduction117
- Setting Parameters117
  - Scanning Sequence Examples117
  - Errors While Scanning118
- Connecting an IBM 468X/469X Host118
- IBM Parameter Defaults119
- IBM Host Parameters120
Chapter 8 Keyboard Wedge Interface123
- Introduction123
- Setting Parameters123
  - Scanning Sequence Examples123
  - Errors While Scanning124
- Connecting a Keyboard Wedge Interface124
- Keyboard Wedge Parameter Defaults125
- Keyboard Wedge Host Parameters126
- Keyboard Map132
- ASCII Character Sets132
Chapter 9 User Preferences & Miscellaneous Options133
- Introduction133
- Setting Parameters133
  - Scanning Sequence Examples134
  - Errors While Scanning134
- User Preferences/Miscellaneous Options Parameter Defaults134
- User Preferences137
- Miscellaneous Scanner Parameters163
Chapter 10 Image Capture Preferences171
- Introduction171
- Setting Parameters171
  - Scanning Sequence Examples172
  - Errors While Scanning172
- Image Capture Preferences Parameter Defaults172
- Image Capture Preferences174
Chapter 11 Symbologies195
- Introduction195
- Setting Parameters195
  - Scanning Sequence Examples196
  - Errors While Scanning196
- Symbology Parameter Defaults196
- Enable/Disable All Code Types202
- UPC/EAN/JAN203
  - UPC-A203
  - UPC-E203
  - UPC-E1204
  - EAN-8/JAN-8204
  - EAN-13/JAN-13205
  - Bookland EAN205
  - Bookland ISBN Format206
  - ISSN EAN207
  - Decode UPC/EAN/JAN Supplementals208
  - User-Programmable Supplementals211
  - UPC/EAN/JAN Supplemental Redundancy211
  - UPC/EAN/JAN Supplemental AIM ID Format212
  - Transmit UPC-A Check Digit213
  - Transmit UPC-E Check Digit213
  - Transmit UPC-E1 Check Digit214
  - UPC-A Preamble215
  - UPC-E Preamble216
  - UPC-E1 Preamble217
  - Convert UPC-E to UPC-A218
  - Convert UPC-E1 to UPC-A218
  - EAN/JAN Zero Extend219
  - UCC Coupon Extended Code219
  - Coupon Report220
  - UPC Reduced Quiet Zone221
- Code 128222
  - Set Lengths for Code 128222
  - GS1-128 (formerly UCC/EAN-128)224
  - ISBT 128224
  - ISBT Concatenation225
  - Check ISBT Table226
  - ISBT Concatenation Redundancy226
  - Code 128 <FNC4>227
  - Code 128 Security Level228
  - Code 128 Reduced Quiet Zone230
- Code 39231
  - Trioptic Code 39231
  - Convert Code 39 to Code 32232
  - Code 32 Prefix232
  - Set Lengths for Code 39233
  - Code 39 Check Digit Verification234
  - Transmit Code 39 Check Digit235
  - Code 39 Full ASCII Conversion235
  - Code 39 Security Level236
  - Code 39 Reduced Quiet Zone238
- Code 93239
  - Set Lengths for Code 93239
- Code 11241
  - Set Lengths for Code 11241
  - Code 11 Check Digit Verification243
  - Transmit Code 11 Check Digits244
- Interleaved 2 of 5 (ITF)245
  - Set Lengths for Interleaved 2 of 5245
  - I 2 of 5 Check Digit Verification247
  - Transmit I 2 of 5 Check Digit248
  - Convert I 2 of 5 to EAN-13248
  - I 2 of 5 Security Level249
  - I 2 of 5 Reduced Quiet Zone250
- Discrete 2 of 5 (DTF)251
  - Set Lengths for Discrete 2 of 5251
- Codabar (NW - 7)253
  - Set Lengths for Codabar253
  - CLSI Editing255
  - NOTIS Editing255
  - Codabar Upper or Lower Case Start/Stop Characters256
- MSI257
  - Set Lengths for MSI257
  - MSI Check Digits259
  - Transmit MSI Check Digit(s)259
  - MSI Check Digit Algorithm260
  - MSI Reduced Quiet Zone260
- Chinese 2 of 5261
- Matrix 2 of 5262
  - Set Lengths for Matrix 2 of 5262
  - Matrix 2 of 5 Check Digit264
  - Transmit Matrix 2 of 5 Check Digit264
- Korean 3 of 5265
- Inverse 1D266
- GS1 DataBar267
  - GS1 DataBar Omnidirectional (formerly GS1 DataBar-14)267
  - GS1 DataBar Limited267
  - GS1 DataBar Expanded268
  - Convert GS1 DataBar to UPC/EAN/JAN268
  - GS1 DataBar Security Level269
  - GS1 DataBar Limited Margin Check270
- Symbology-Specific Security Features271
  - Redundancy Level271
  - Security Level273
  - 1D Quiet Zone Level274
  - Intercharacter Gap Size275
- Composite276
  - Composite CC-C276
  - Composite CC-A/B276
  - Composite TLC-39277
  - Composite Inverse277
  - UPC Composite Mode278
  - Composite Beep Mode279
  - GS1-128 Emulation Mode for UCC/EAN Composite Codes279
- 2D Symbologies280
  - PDF417280
  - MicroPDF417280
  - Code 128 Emulation281
  - Data Matrix282
  - GS1 Data Matrix282
  - Data Matrix Inverse283
  - Decode Data Matrix Mirror Images284
  - Maxicode285
  - QR Code286
  - GS1 QR286
  - MicroQR287
  - Aztec287
  - Aztec Inverse288
  - Han Xin289
  - Han Xin Inverse290
- Macro PDF Features291
  - Flush Macro Buffer291
  - Abort Macro PDF Entry291
- Postal Codes292
  - US Postnet292
  - US Planet292
  - Transmit US Postal Check Digit293
  - UK Postal293
  - Transmit UK Postal Check Digit294
  - Japan Postal294
  - Australia Post295
  - Australia Post Format296
  - Netherlands KIX Code297
  - USPS 4CB/One Code/Intelligent Mail297
  - UPU FICS Postal298
  - Mailmark298
Chapter 12 OCR Programming299
- Introduction299
- Setting Parameters299
  - Scanning Sequence Examples300
  - Errors While Scanning300
- OCR Parameter Defaults300
- OCR Programming Parameters301
Chapter 13 Intelligent Document Capture331
- Introduction331
- The IDC Process331
- PC Application and Programming Support333
- Setting Parameters334
- Quick Start349
Chapter 14 DigiMarc Bar code353
- Introduction353
- DigiMarc Symbology Selection353
  - Picklist353
- DigiMarc Bar Codes354
Chapter 15 Driver’s License Set Up (DS8108-DL)355
- Introduction355
- Driver’s License Parsing356
- Parsing Driver’s License Data Fields (Embedded Driver's License Parsing)357
- User Preferences371
- Parsing Rule Example393
  - Embedded Driver's License Parsing ADF Example397
Chapter 16 123Scan and Software Tools399
- Introduction399
- 123Scan399
- Scanner Control App402
- Advanced Data Formatting (ADF)402
- Multicode Data Formatting (MDF)403
  - Programming Options403
  - MDF Terms and Definitions403
- Preferred Symbol404
  - Programming Options404
Appendix A Standard Parameter Defaults405
Appendix B Numeric Bar Codes419
- Numeric Bar Codes419
- Cancel421
Appendix C Alphanumeric Bar Codes423
- Cancel423
- Alphanumeric Bar Codes424
Appendix D ASCII Character Sets441
Appendix E Programming Reference453
- Symbol Code Identifiers453
- AIM Code Identifiers455
Appendix F Communication Protocol Functionality461
- Functionality Supported via Communication (Cable) Interface461
Appendix G Country Codes463
- Introduction463
- USB and Keyboard Wedge Country Keyboard Types (Country Codes)464
Appendix H Country Code Pages479
- Introduction479
- Country Code Page Defaults479
- Country Code Page Bar Codes483
Appendix I CJK Decode Control493
- Introduction493
- CJK Control Parameters494
- Unicode/CJK Decode Setup with Windows Host499
Appendix J Signature Capture Code503
- Introduction503
- Code Structure503
  - Signature Capture Area503
  - CapCode Pattern Structure504
- Start / Stop Patterns504
- Dimensions505
- Data Format505
- Additional Capabilities506
- Signature Boxes506
Appendix K Non-Parameter Attributes (Attribute Data Dictionary)507
- Introduction507
- Attributes507
Appendix L Sample Bar Codes513
- UPC/EAN513
- Code 128516
  - GS1-128517
- Code 39517
- Code 93517
- Code 11 with 2 Check Digits518
- Interleaved 2 of 5518
- MSI with 2 Check Digits518
- Chinese 2 of 5519
- Matrix 2 of 5519
- Korean 3 of 5519
- GS1 DataBar520
- 2D Symbologies521
- Postal Codes524
- OCR526
Index527

Table of Contents

Related product manuals