Zebra DS8108

9 - 10 DS8108 Digital Scanner Product Reference Guide
Direct Decode Indicator
Parameter # 859
SSI # F2h 5Bh
This parameter is only supported in Auto Aim and Standard (Level) Hand-held Trigger Mode. Scan one of the
following bar codes to select optional blinking of the illumination on a successful decode if you continue to hold the
trigger. If you release the trigger upon decode, the blinking does not occur. This allows you to choose additional
feedback for a successful decode by holding the trigger, or to continue to scan as normal.
• *Disable Direct Decode Indicator - Illumination does not blink on a successful decode.
• 1 Blink - Illumination blinks once upon a successful decode.
• 2 Blinks - Illumination blinks twice upon a successful decode.
*Disable Direct Decode Indicator
(0)
1 Blink
(1)
2 Blinks
(2)