11 - 28 DS8108 Digital Scanner Product Reference Guide
Code 128
Parameter # 8
SSI # 08h
Scan one of the following bar codes to enable or disable Code 128.
Set Lengths for Code 128
L1 = Parameter # 209
SSI # D1h
L2 = Parameter # 210
SSI # D2h
The length of a code refers to the number of characters (i.e., human readable characters), including check digit(s)
the code contains. Set lengths for Code 128 to any length, one or two discrete lengths, or lengths within a specific
range. The default Any Length.
Scan one of the following bar codes to select a length option:
•
One Discrete Length - Decode only Code 128 symbols containing a selected length. Select the length using
the bar codes in Appendix B, Numeric Bar Codes. For example, to decode only Code 128 symbols with 14
characters, scan Code 128 - One Discrete Length, and then scan 1, 4. To correct an error or change the
selection, scan Cancel on page B-3.
•
Two Discrete Lengths - Decode only Code 128 symbols containing either of two lengths. Select lengths
using the bar codes in Appendix B, Numeric Bar Codes. For example, to decode only Code 128 symbols
containing either 2 or 14 characters, scan Code 128 - Two Discrete Lengths, and then scan 0, 2, 1, 4.
To correct an error or change the selection, scan Cancel on page B-3.
•
Length Within Range - Decode Code 128 symbols with a specific length range. Select lengths using
the bar codes in Appendix B, Numeric Bar Codes. For example, to decode Code 128 symbols containing
between 4 and 12 characters, scan Code 128 - Length Within Range, and then scan 0, 4, 1, 2. To correct
an error or change the selection, scan Cancel on page B-3.
*Enable Code 128
(1)
Disable Code 128
(0)
NOTE When setting lengths, enter a leading zero for single digit numbers.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
