Application Deployment
171
9.
Press the Up and Down arrow keys to navigate to the Factory Reset file.
10. Press the Enter key or Power button to start the Factory Reset. After the Factory Reset the device
returns to the Recovery screen.
11. Navigate to Reboot system now and press the Enter key or Power button to reboot the device.
Performing a Factory Reset Using ADB
To perform an Factory Reset using ADB:
1. Connect the device to the Rugged Charge/USB cable or insert the device into the 1-Slot USB/Charge
Only Cradle.
2. Connect the cable or cradle to the host computer.
3. Go to Settings.
4. Touch System > Advanced > Developer options.
5. Slide the switch to the ON position.
6. Touch USB Debugging. A check appears in the check box. The Allow USB debugging? dialog box
appears.
7. Touch OK.
8. On the host computer, open a command prompt window and type:
adb devices.
The following displays:
List of devices attached
XXXXXXXXXXXXXXX device
(where XXXXXXXXXXXXXXX is the device number).
NOTE: If device number does not appear, ensure that ADB drivers are installed properly.
9. Type the following and press Enter:
adb reboot recovery
The System Recovery screen appears on the device.
10. Press the Up and Down arrow keys to navigate to apply from adb.
11. Press the Enter key or Power button to select.
12. Press the Up and Down arrow keys to navigate to Full OTA Package.
13. Press the Enter key or Power button to select.
14. On the host computer command prompt window type the following and press Enter:
adb sideload <file>
where: <file> = the path and filename of the zip file.
The Factory Reset package installs and then the System Recovery screen appears on the device.
15. Navigate to Reboot system now and press the Enter key or Power button to reboot the device.
Storage
The device contains the following types of file storage:
mc33-ug-en.book Page 171 Thursday, July 9, 2020 10:34 AM
To Next Page
Loading...
Need help?
General
