Zebra MC3300X User Manual

Data Capture
86
3.
Align the NFC icon on the RS5100 or RS6000 with the NFC icon on the back of the device.
The Status LED blinks blue indicating that the RS5100 or RS6000 is attempting to establish connection
with the device. When connection is established, the Status LED turns off and the RS5100 or RS6000
emits a single string of low/high beeps.
A notification appears on the MC3300x screen.
Figure 37 Align NFC Antennas
The device pairs with the RS5100 or RS6000 and appears in the Status bar.
Pairing in HID Mode Using Near Field Communication
The device provides the ability to pair the RS5100 or RS6000 in HID Mode using NFC.
1. Ensure that NFC is enabled on the device.
2. Ensure that Bluetooth is enabled on both devices.
3. Place the RS5100 or RS6000 in Human Interface Device (HID) mode. If the RS5100 or RS6000 is
already in HID mode, skip to step 6.
a. Remove the battery from the RS5100 or RS6000.
b. Press and hold the Restore key.
c. Install the battery onto the RS5100 or RS6000.
d. Keep holding the Restore key for about five seconds until a chirp is heard and the Scan LEDs flash
green.
e. Scan the barcode below to place the RS5100 or RS6000 in HID mode.
Figure 38 Bluetooth HID Barcode
4. Remove the battery from the RS5100 or RS6000.
5. Re-install the battery into the RS5100 or RS6000.
mc33-ug-en.book Page 86 Thursday, July 9, 2020 10:34 AM

Zebra MC3300X Specifications

General

Storage	32 GB
Operating Temperature	-4°F to 122°F/-20°C to 50°C
Processor	Qualcomm Snapdragon™ 660 octa-core, 2.2 GHz
Operating System	Android 11
RAM	4 GB
Display Size	4.0 inches
Display Resolution	480 x 800 pixels
Connectivity	Wi-Fi, Bluetooth
Camera	13 MP rear
Drop Specification	Multiple 6 ft./1.8 m drops to concrete across the operating temperature range
Sealing	IP65
Touch Panel	Capacitive
Scanning	1D/2D barcode scanning
Battery Type	Li-Ion