Getting Started
30
2. The mobile computer starts to charge automatically. The Charge LED Indicator indicates the charge
status. See the table below for charging indications.
To charge the mobile computer using the cables:
1. Connect the MC3300x Communication/Charge Cable to the appropriate power source and connect to
the mobile computer. See Accessories for accessory setup.
2. The mobile computer starts to charge automatically. The Charge LED Indicator indicates the charge
status.
Charging Indicators
The MC3300x 7000 mAh PowerPrecision+ extended battery charges from 0% to 90% in less than 5.2
hours at room temperature.
The MC33XX 5200 mAh PowerPrecision+ high capacity battery charges from 0% to 90% in less than 3.8
hours at room temperature.
The MC33XX 2740 mAh PowerPrecision+ standard battery charges from 0% to 90% in less than 2.2 hours
at room temperature.
Charging Temperature
Charge batteries in ambient temperatures from 0°C to 40°C (32°F to 104°F). To view battery temperature,
go to Settings > About phone > Battery information.
The device or cradle always performs battery charging in a safe and intelligent manner. At higher
temperatures (for example, approximately +37°C (+98°F)) the device or cradle may for small periods of
time alternately enable and disable battery charging to keep the battery at acceptable temperatures. The
device and cradle indicates when charging is disabled due to abnormal temperatures via its LED.
NOTE: To function properly, ensure that the MC3300x hand strap, if attached, does not interfere with the
charging contacts when the MC3300x is inserted into a charging cradle or cable.
Table 8 LED Charge Indicators
Status Indications
Off • The battery is not charging.
• The battery is not inserted correctly in the
cradle or connected to a power source.
• Cradle is not powered.
Blinking Amber • Active wireless connectivity session during
battery hot swap.
Solid Amber • Battery is charging.
Solid Green • Battery charging is complete.
Fast Blinking Red
2 blinks/second
Charging error, e.g.:
• Temperature is too low or too high.
• Charging has gone on too long without
completion (typically eight hours).
mc33-ug-en.book Page 30 Thursday, July 9, 2020 10:34 AM
To Next Page
Loading...
Need help?
General
