Zebra MC3300X - Touch Panel Mode; Setting the Date and Time

Settings
47
4.
Select one of the font size values.
• Small
• Default
• Large
• Largest.
5. Touch the Home button.
Touch Panel Mode
The device display is able to detect touches using a finger, a conductive-tip stylus, or gloved finger.
NOTE: A glove can be made of medical latex, leather, cotton, or wool.
For optimal performance use a Zebra certified stylus.
1. Go to Settings.
2. Touch Display > Advanced.
3. Touch Touch panel mode.
4. Select:
a. Finger and Stylus to use a finger or a stylus on the screen.
b. Finger and Glove to use a finger or a gloved finger on the screen.
5. Touch the Home button.
Setting the Date and Time
You are only required to set the time zone or set the date and time if the wireless LAN does not support
Network Time Protocol (NTP).
1. Go to Settings.
2. Touch System > Date & time.
3. Touch Date.
4. In the calendar, set today’s date.
5. Touch OK.
6. Touch Time.
7. Touch the green circle, drag to the current hour and then release.
8. Touch the green circle, drag to the current minute and then release.
9. Touch AM or PM.
10.Touch OK.
11.Touch Use 24-hour format.
12.Touch the Home button.
mc33-ug-en.book Page 47 Thursday, July 9, 2020 10:34 AM